FORD FAIRLANE (1968 - 1970) *please note calipers come painted in green black or zinc sometimes a left and right or different colours at present this is how it is so you may have to paint them to get them matching if you are not prepared to do this please don't buy them
Also note you can fit this caliper on the opposite side by mistake and the brakes wont bleed as the nipple
has to be at the top some make sure you are ordering the correct side first in case some one has fitted then
Incorrectly*
FORD FALCON (1968 - 1970)
FORD MUSTANG (1968 - 1973)
FORD RANCHERO (1968 - 1971)
FORD TORINO (1968 - 1971)
MERCURY COMET (1968 - 1969)
MERCURY COUGAR (1968 - 1973)
MERCURY CYCLONE (1968 - 1971)
MERCURY MONTEGO (1968 - 1971
Reman.; Includes: Caliper and Hardware
A1 CARDONE Remanufactured Friction Choice ® Brake Calipers are remanufactured to meet or exceed O.E.M. performance. With the freedom to choose whatever friction you desire, A1 CARDONE Remanufactured Friction Choice Brake Calipers can be tailored to meet your needs.
Features
Most common reasons for failure are:
Corrosion caused by internal water intrusion (brake fluid absorbs water).
Sticking or frozen pins, bolts, or slides that cause excessive inboard pad wear.
Contamination from the brake system.
Improper fluid when used in a system which uses a petroleum based fluid will cause all rubber components in the brake system to swell.
Frozen bleeder valves in the caliper housing due to external corrosion.
Overheating due to residual pressure from the brake system not allowing the piston to return.
On rear calipers, failure to use the parking brake regularly causes the parking mechanism to corrode preventing the caliper from being properly adjusted.
IMPORTANT: Calipers should be replaced in pairs to prevent uneven braking. The brake system should be thoroughly flushed with the recommended fluid from a sealed container and the sliding surfaces must be lubricated with the proper grease for your application.
Installation Instructions
Top Ten Caliper Replacement Tips
Bleeder Port Size 3/8 x 24
Brake Caliper Finish Unfinished
Brake Piston Count 1
Casting Material Iron
Color/Finish Gray
Inlet Port Size 3/8 x 24
Installation Hardware Included? Yes
Mounting Bolts Included? No
Package Contents Caliper, Hardware Kit
Pads Included? No
Piston Material Steel
Piston Size (OD) 2.370"
Product Condition Remanufactured
